P-GAQ FUEL DISPENSER

P-GAQ FUEL DISPENSER

FlowMeter Type: Optional

Accuracy :±0.2%

Pressure Loss (kg/cm):Under 0.25

Motor Voltage(V) :110V/220V/380V,50Hz/60Hz

Capacity(hp) :1HP(0.75kw)

Input Voltage : 110V/220V/380V,50Hz/60Hz

Nozzle :Auto Shut-off Nozzle

Environmental Condition : -40~~+55degree

Control Type :Solenold Vale Control Type

Preset : Function Provided(Small LCDIndicator)

Display(Counter) :Type LCD and Bright Backlight

Digit of Volume : 0~~999,999(6 Digits),Decimal point can be changed

Digit of Amount :0~~999,999(6 Digits),Decimal point can be changed

Digit of Unit price : 0~~9999(4 Digits),Decimal point can be changed

Digit of Total Range :0~~99,999,999,99

Optional Display :Type LCD and Bright Backlight

Digit of Volume : 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Amount :0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Unit price : 0~~999999(6 Digits),Decimal point can be changed

Digit of Total Range :0~~99,999,999,99

Totalizer: 1~~9,999,999

Hose :4.5m

Weight :280kg

Dimension(L×W×H) :1060*550*1620(mm)

Dimension(L×W×H)Of Qty of Container: 40ft: 44 20ft: 22

e hydraulic pulse so as to increase inner discharge of measurement transducer, affecting fuel dispenser’s accuracy. The incorrect pipeline installation makes the whole hydraulic system much unstable --- pressure pulse increases. As higher oil temperature or vacuum pressure, oil viscidity will reduce, affecting measurement transducer in t fuel dispenser wo facets. One is to increase inner leak, the other is to decline the stability of hydraulic system. From above analysis, it is known that high vacuum pressure of pump inlet is not always good for fuel dispenser’s normal operation. One pipe connect to several fuel dispensers Some filling stations, in order to reduce installation cost, adopt one pipe to connect several fuel dispensers, which is very unscientific. In this type of installation there would be brought two facets of troubles: one is that, as some fuel dispensers stop operations, some still work, air would be suck from stopped dispensers so as to affect the accuracy of working fuel dispensers. The other trouble is that if several fuel dispensers work at same time, there would be mutually interfering, increasing flow pulse and inner leakage so as to affect accuracy. 1 fuel dispenser .2 Pipeline installation in positive pressure Delivery oil through positive pressure refers to in delivery process the inlet of fuel dispenser is positive pressure, which is adopted in the following situations. One is that delivery oil from high position tank, the other situation is tat adopt submersible pump in tank to delivery oil to fuel dispenser. The latter situation is more often. fuel dispenser The Article 6.2.6 in GB50156-2002 the Design and Construction of Vehicle Filling station stipulated that if several fuel dispensers adopt same one pipe, each is affected and lead to uneven influx. Therefore, in order to ensure accuracy, the pipeline between fuel dispenser and tank should scientifically design and installation, using as few as elbow, keeping inner wall smooth of pipe. These are beneficial to reduce pressure and electricity loss, and to decl

housings above a Type 1 or a Type 2 vapour barrier do not require ventilation.　　 5.3.7.5.2 Column extensions without vapour barriers　　 The enclosed fabrication will be considered as an extension of the hazardous areas unless:　　 a) 25 % or more of its surf fuel dispenser ace area constitutes aperture(s) open to free air; and　　 b) the ventilation extends completely to the junction of the hydraulic housing so as to ensure that no vapour trap　　 can remain below the lowest ventilation aperture.　　 5.4 Safety requirements related to electromagnetic phenomena　　 -- - - ---　　 The equipment shall have sufficient immunity to electromagnetic disturbances to enable them to operate safely as　　 intended and not fail to danger when exposed to the levels and types of disturbances intended by the　　 manufacturer. The manufacturer of the equipment shall design install and wire the equipment and sub-assemblies　　 taking into accoun fuel dispenser t the recommendations of the suppliers of these sub-assemblies.　　 6 Tests　　 6.1 Type tests　　 6.1.1 General　　 All tests within 6.1.2 to 6.1.9 shall be in the sequence shown.　　 All pressures are relative to at fuel dispenser mospheric pressure i.e. gauge pressure.　　 All tests shall be performed at (20 �?5) 掳C unless otherwise stated.　　 6.1.2 Sight glass test　　 6.1.2.1 Purpose　　 To confirm that the sight glass is of sufficient strength. For criteria see 5.3.4.6.　　 6.1.2.2

s three-term Democratic senator, suffered the unusual embarrassment of being rejected by his own party. Ned Lamont, a fresh-faced multimillionaire, ran on an anti-war platform and won the Democratic primary with 52% of the vote. He would have coasted to Washington, except that Mr Lieberman had already pledged to run as an independent fuel dispenser if he lost the primary. On Tuesday, having lost by 40% to 49%, Mr Lamont called Mr Lieberman to concede defeat. After the August primary, Mr Lieberman s return to the Senate was delicate. His Democratic colleagues, most of whom had endorsed Mr Lamont, did not know how to deal with him, or whether it was worth doing so. That second question has now been settled. Answering the first will be a top priority in the new—presumably Democratic, but tightly split—Senate. For Mr Lieberman, a swing vote if ever there was one, probably holds the balance of power. During the campaign, he promised often that he would behave as a Democrat. In his victory speech, he qualified that promise. “I will go to Washington beholden to no political group,�?he said. No one knows to what extent Mr Lieberman will toe the Democrat line when he returns t fuel dispenser o the Senate. He has repeatedly criticised the “politics of partisanship�?in recent weeks. Exit polls suggest that he received more support from Republicans and independents than Democrats. It is also well known that Mr Lieberman not only supports the Iraq war, but is at times downright chummy with George Bush. Working the crowd after his 2005 state-of-the-union address, for example fuel dispenser , Mr Bush appeared to give Mr Lieberman a kiss. The embrace inspired one of the odder artefacts of this campaign season a papier-mâché sculpture, mounted on the back of a pickup truck, showing the two men smooching. If anything, though, Mr Lieberman won despite his support of the war and his friendship with the president, and despite the efforts of the liberal groups who opposed a sitting Democrat. Mr Lieberman chipped away at Mr Lamont s an